Wall sheets Biddy cannot place are asked about, all at once

Elevation and render sheets are where the wall sizes are. Most of them land on the right room without asking, because their title matches a room you have. Some don't:

• the designer titles the sheet Guest Kitchen and your card is Guest Suite Living
• the architect titles one Primary Shower when the room is the Primary Bath
• a sheet prints sizes and no room name at all

Before, a sheet like that could end up on a question that only offered the wrong rooms, or not show up at all, and its sizes never reached your bid.

One question, one row per sheet

Now every sheet like that goes on one check:

These sheets show tile sizes but I can't tell which room they're for

Each sheet gets its own row, with the sheet beside it (tap the picture to open it) and what it measured, such as Backsplash 61.5 sq ft · sheet 3. Each row has a Which room? picker. The rooms it most looks like are at the top, and every room in your bid is on the list, so the right room is always there.

Pick the room and that sheet's sizes land on its card as suggestions, the same way every other elevation's do. Nothing prices until you accept it. The other sheets stay on the check until you get to them.

Two ways out

• Not in this bid sets that sheet aside for good. Nothing from it lands, and you're not asked about it again.
• None of these, add a new room puts the sheet's room on the list of rooms you can add.

Not sure, skip puts the whole check away. Re-reading won't bring those sheets back, but a sheet from a file you add later still gets asked about.